Grease Injection and Hydraulic Union

Description The Grease Injection and Hydraulic Union is designed to operate wireline valve (BOP), grease injection head (GIH), stuffing box, tool catcher, tool trap, cable cutter, line wiper & pack off and etc. During wireline intervention, the Greas...

Wireline Valve (BOP)

Description The Wireline Valves or BOP’s have been designed for use as part of a complete wireline intervention string. The primary purpose is to provide a manageable safety barrier during remedial work on a wireline. The valves are designed to contr...

Quick Test Sub

Description The Quick Test Sub takes the place of the bottom of tool trap and becomes the joint that is broken each time. Because of its unique design, it can be tested in isolation from the rest of the rig up by the simple use of a small hand pump. ...

Wellhead Adapter Flange

Description Wellhead Adapter Flange consists of a quick union machined on a standard API flange. The upper end has a standard Bowen or Otis Type Quick Union and can be supplied with a blanking plug and collar if required. Structural Features ● API 6...

Pump-in Sub

Description A Pump-In-Sub (Flow-Tee) is normally placed below a Wireline Valve. It allows for bleeding off of well gases and fluids from a pressure control stack. The Pump-In-Sub assists in introduction of fluids to a well for well control purposes. ...

Tool Trap

Description The tool trap (or tool retainer) is a safety device normally installed immediately above the wireline valve. Its purpose is to retain any wireline down-hole equipment that may be accidentally "pulled off" inside the lubricator and prevent...

Luburicator

Description Lubricators are used to allow the wireline tool string to be raised above the wellhead valve prior to and after wireline operations and enable the wellhead valve to be opened and closed allowing entry and exit of the toolstring from the w...

Tool Cather

Description The Hydraulic Wireline Tool Catcher has been designed for use as part of the clients subsea string. The primary purpose is as a safety device. If the tool is pulled above the tool catcher and the wire is stripped from the rope socket, the...

Grease Injection Control Head

Description The LENGTHON Grease Injection Control Head have been designed for use as part of a complete wireline intervention string. The primary purpose is to create a seal around a moving wireline, allowing intervention access to wells under pressu...

Combined Stuffing Box/Line Wiper

Description The Combination Stuffing Box and Line Wiper is designed for use with wireline grease injection control heads, for wiping excess grease from the moving wire and for packing off on a stationary wire. The Combination Stuffing Box and Line Wi...